WARP 10 Car Kits

[Schraddel]

Hello,

next day:


Started over to complete the bodies.





In the event the floors of both cars were about 1mm too narrow to fith the width of the front walls. This was resulting in gaps between floor and side walls.





To close the gaps and to reinforce the bodies, i glued strips of 4x4mm ABS into the corners between floor and sidewall. At one car i had glued floor and sidewall directly before i become aware of the too small floors. Hence this car is a little bit asymmetrical ...





Therefor one sidewall of the other car was a liitle bit too short. Counterchecking resulted that all 4 corners were square at 90° angle ss they shoudl be.
I fixed this with a 0.5mm styrene strip.

You have no chance to built these kits without a certain talent of improvisation.


Lutz