01-27-2021, 02:15 PM
Wayne,
the convertible model is a Wanderer which was made by Brekina several years ago (out of production):
https://www.google.com/search?sxsrf=ALeK...76&bih=672
Here i replaced the too small wheels by contemporary spoked ones. The front axle was reset about 1mm forward. So the center of axle now is sitting just beneath the highest point of the curvature of the front wings.
As i am planning to reproduce a gas filling up scene, the trunk in the rear got a bore approximetely were a filler cap may be situated.
One of the gas pump nozzles was then glued into this bore.
But wait a little, then you will see the whole scene.
Lutz
the convertible model is a Wanderer which was made by Brekina several years ago (out of production):
https://www.google.com/search?sxsrf=ALeK...76&bih=672
Here i replaced the too small wheels by contemporary spoked ones. The front axle was reset about 1mm forward. So the center of axle now is sitting just beneath the highest point of the curvature of the front wings.
As i am planning to reproduce a gas filling up scene, the trunk in the rear got a bore approximetely were a filler cap may be situated.
One of the gas pump nozzles was then glued into this bore.
But wait a little, then you will see the whole scene.
Lutz