05-09-2009, 05:55 AM
Hi All,
When i do a DCC install on a loco a piece of kapton tape across the top of the chassis to either side makes a good hold for wires as you progress, thread each wire through neatly after lifting the edge of the tape with a toothpick and lay the wires inline and flat ..... makes for a lot neater job and in the future the wiring can be traced easily should problems occur.
When i do a DCC install on a loco a piece of kapton tape across the top of the chassis to either side makes a good hold for wires as you progress, thread each wire through neatly after lifting the edge of the tape with a toothpick and lay the wires inline and flat ..... makes for a lot neater job and in the future the wiring can be traced easily should problems occur.
<!-- m --><a class="postlink" href="http://www.freewebs.com/upnick/">http://www.freewebs.com/upnick/</a><!-- m -->
![[Image: up_xm40o.gif]](http://i549.photobucket.com/albums/ii377/upnick/up_xm40o.gif)
![[Image: up_lo-1.gif]](http://i549.photobucket.com/albums/ii377/upnick/up_lo-1.gif)
![[Image: up_turb10k_r.gif]](http://i549.photobucket.com/albums/ii377/upnick/up_turb10k_r.gif)