01-24-2024, 02:55 PM
After looking at it and realizing I made a mistake, I had to add just a small amount of water to drag the decals under the numbers down a little bit to get them in the correct position. The one side of the hopper car now has all the decals on it and that will dry for about an hour or so before I start the other side. So here below is what is done as of right now.
Matt
Conrail's Blairsville Cutoff - A Fictitious Alternative Route Over The Allegheny Mountains From Blairsville, Pa to Cresson, Pa
Milepost 363.8 to Milepost 338.9