08-02-2024, 06:01 PM
Glued some tar paper to the roof. That also squared up the top of the building, but it bulged out in the middle on the short side, so I decided to add more stiffeners and straighteners to the back side.
Scratched the A/C unit on the roof. I figure a much more suitable location would be at the center of the building, not out on the corner. At any rate, I folded up some brick interior walls for the roof from a brick wall off of the "Plant #2" kit into four-sided columns that snugged up to the brick front wall on the roof.
I then folded up some concrete caps from the leftover "basement" story on this kit and glued them on top of the brick for a finished roof cap.
Phase 1 (of 3 I think), complete. Phase 2 will be a 4-story of about the same length, but I'm going to pull it away from the wall a bit more and it'll be geographically lower than Phase 1.
Scratched the A/C unit on the roof. I figure a much more suitable location would be at the center of the building, not out on the corner. At any rate, I folded up some brick interior walls for the roof from a brick wall off of the "Plant #2" kit into four-sided columns that snugged up to the brick front wall on the roof.
I then folded up some concrete caps from the leftover "basement" story on this kit and glued them on top of the brick for a finished roof cap.
Phase 1 (of 3 I think), complete. Phase 2 will be a 4-story of about the same length, but I'm going to pull it away from the wall a bit more and it'll be geographically lower than Phase 1.
Check out my "Rainbows in the Gorge" website: http://morristhemoosetm.wixsite.com/rainbows