Juneco Two stall enginehouse

[cnrglen]

Thank you.
I did a bit more on the roof today.
   

I attached the rafters to the roof panels. One at a time I used some steel blocks to ensure each was straight and square. I also taped the two roof panels together.

   

The five rafters are inset from the ends and their location match up to the vertical beams in the side walls.  There is a different 'rafter' assembly for the ends of the roof.

   

Then I applied glue the the other side of the ratfer tops and pulled them down to mate with the other roof side.

   
   
when the glue was dry I flipped the roof over and tested it for flatness on the table, and then on the model itself. So far, so good.