Juneco Two stall enginehouse

[cnrglen]

I finished up with the lighting this morning.
   

As I mentioned before I attached the styrene 'shades' to the walls and then used a drop of tacky glue to attach the leds to the shades. I painted everything (except the lights) black.

   

Then came wiring everything into a central power pickup. It's not the neatest but it gets the job done. I made a second 'terminal block' for the lights and conected everything there. There's still an extra slot for any outside lights I may put in later. As I wired everything up I tested the lights so I would know it worked as I went.

   

And with about 6-7 volts running from an old power pack and the workshop lights on. I'll be running the lighting power at 9 volts so it will be a bit brighter.

   

And with the workshop lights off. They give off a nice glow without being overpowering.

   

Finally with the roof on. The shades seem to be doing their job at keeping the light below the roofline and in the windows. You can't see it in still photos but the flickering LED makes a nice effect in the office of an oil lamp.