10-11-2024, 10:25 AM
(03-14-2024, 12:16 PM)nachoman Wrote: it is overloading my Tech II power pack almost instantly when I get above 1/4 throttle. When it overloads, the motor is very hot (more than just warm - but not to the point of smoking).
I tried replacing the magnet with neodymium magnets, but the result is the same. The motor otherwise starts fine and runs smoothly at low speed.
The magnets worked for me. I had trouble with the motor when I first put it back together. It turns out that I screwed back together too tightly. Once I get it all adjusted the motor ran more quiet with a lower amp draw.