Rainbows in the Lehigh Valley Gorge

[TMo]

Started installing the board fence between the two portions of the brewery - gluing down about four posts at a time and letting the glue setup.

   

While waiting for it to dry, I thought I'd make a second attempt at a billboard to put on top of the lower of the two brewery buildings.  The first attempt (if you remember) was too big in scale and was supported by a massive wood frame.  I was looking for a lighter space frame type thing.  I thought maybe I'd saved an overhead signal bridge in plastic from my early days in the hobby and maybe I could cut a section of that to support the sign, but it was not found after digging through a few boxes of old plastic assembled kits.  I did find an old Tyco rolling crane with a broken truss assembly (that's the green triangular thing in the picture below).  Thought if I used a portion of the larger truss assembly, that might make a reasonable support for the frame of the billboard.  We're going to give it a shot.  I'm spraybombing it black at the moment and I'll be printing the sign out to the right size on cardstock and building some rear support to give it some depth and thickness.