Todd, I did not measure current draw and I can't find the specs for that. I can't even find the specs I had to begin with 
. I did however do a complete stall and didn't burn up the decoder. They make these with even higher rpms which might work better for a passenger locomotive. These are ball bearing motors so draw should be low. I will do some more tests tonight and do some videos. So far I am happy with the exception I found the same motor cheaper while I was searching for specs. I am heartbroken 
Cheap Chuck
. I did however do a complete stall and didn't burn up the decoder. They make these with even higher rpms which might work better for a passenger locomotive. These are ball bearing motors so draw should be low. I will do some more tests tonight and do some videos. So far I am happy with the exception I found the same motor cheaper while I was searching for specs. I am heartbroken Cheap Chuck