01-18-2026, 11:28 PM
Thanks everyone. I got quite a bit done today.
Over the last few days I was pre-painting the wall parts. I used all Vallejo paints. The side walls were Natural Wood grain for the tan, Light Emerald for the teal. The side walls are 4 panels that are laminated together to make the appropiate 3-d effect of the window frames both inside and out. The wall on the right is completed and the parts on the left are 3 of the 4 parts of the other.
And these are the two walls completed, including the exterior trim, which is a single laser-cut piece.
The front and rear walls are similar build, with a couple less parts.
This is how far I got, including painting the cab of the truck. I'll be painting the cab with a semi-gloss clear before detail painting and final assembly.
Over the last few days I was pre-painting the wall parts. I used all Vallejo paints. The side walls were Natural Wood grain for the tan, Light Emerald for the teal. The side walls are 4 panels that are laminated together to make the appropiate 3-d effect of the window frames both inside and out. The wall on the right is completed and the parts on the left are 3 of the 4 parts of the other.
And these are the two walls completed, including the exterior trim, which is a single laser-cut piece.
The front and rear walls are similar build, with a couple less parts.
This is how far I got, including painting the cab of the truck. I'll be painting the cab with a semi-gloss clear before detail painting and final assembly.