11-12-2026, 07:57 PM
(11-12-2026, 04:36 PM)Charlie B Wrote:(11-12-2026, 01:29 PM)LiveSteamer Wrote: They are both DCC ready which I found out after removing the shells and seen the dummy plugs for the computer boards. I am not 100% sure which DCC maker it is so any help from you guys would be awesome. Then I can go and get the plug and a DCC system.
Matt, if the plug is there any brand decoder should work. basically depends on how many functions you want. for non sound units i lately have been using digitrax DZ123PS which is small and just plugs in. it only has front and rear lights but that is all I use on most of my locomotives. Shop around and find them for less tham 20 bucks. decoder
As for system I like the MRC Prodigy advance squared but the NCE and Digitrax are good systems too. If you add a wifi adapter you can run the trains with your phone.
Charlie
Matt,
I also run with an MRC Prodigy (the Express (squared)) combined with an MRC booster unit (a Power Station 8 which brings up my current capacity from about 1.6 amps (enough to run 3 locos consisted at full speed) to over 8 amps (roughly 16 locos simultaneously)), and if you're on the lookout, you can find these occasionally at a good price. For comparison, Charlie's Prodigy Advanced (squared) provides 3.5 amps by itself without a booster, but the price is higher than my Express. Lenz, TCS and Digitrax also make good dependable DCC systems which both get better reviews (generally) than MRC, but you'll probably have to shell out more money. With model railroaders dying off or giving up on the hobby, if you're patient, you should be able to pick up something used that will work.
Another option is to run your purchased locos in analog mode - they should probably have been sent to you with an adapter that plugs into the DCC plug until you decide on an appropriate DCC system that works for you and your layout.
I'm in agreement with Charlie on decoders - most should work with your plug (I'm assuming an 8-pin in those Atlas units (newer DCC ready use a 22-pin plug which allows for greater function programming)). You do want to make sure the decoder you order has the capabilities you're looking for, since DCC providers offer stationary decoders (to control turnouts or layout lighting, mobile (locomotive) decoders without sound, and mobile decoders with sound). As you increase in capability, so do the prices of each, with sound decoders roughly doubling in price over the non-sound decoders. Mobile decoders are also rated by scale - sometimes you can get away with an N-gauge decoder in an HO locomotive, but you're probably asking for trouble. Like Charlie, I'm also a fan of Digitrax decoders. If you need more functions than 2 (directional lighting control, front and rear lights), the Digitrax decoder models with a "4" or a "6" in their catalog number (instead of the 2 in the DZ123PS) will provide the capability to add things like ditch lights, strobe lighting, classification lighting, etc.
Once you do find the right decoder, you'll find that for the 8-pin plugs, it is possible to plug the decoder in two different ways - pay attention to the correct orientation for right and left side track that the decoder manual will provide, and you should then have appropriate forward, reverse, and front and rear lighting functions. It's then possible to change the polarity of the entire loco by altering some Control Variables (CVs) in order to run that locomotive "backward" in a consist. You can also change how fast the locomotive accelerates, decelerates, what the maximum speed will be, etc. A whole new world opens up for exploration (full of pros AND cons...).
Check out my "Rainbows in the Gorge" website: http://morristhemoosetm.wixsite.com/rainbows
