07-13-2009, 01:27 PM
leon Wrote:Why not just use a 1 inch C-clamp. Cut a slot in the end for the axle and take off the round 'foot' and file down the screw to the size of the axle and you are in buisness. To install a new wheel just put the 'Foot' back on and press on the wheel. (what I mean by 'FOOT' is the round button that presses against the parts to be clamped.) No welding required! (PS: I seen this in a MRR mag quite a few moons ago)
Sounds like a neat idea ----- anybody wanna buy some welding rod-- never been used?
Instant glue ? ---- SOLDER ---- NOW THATS INSTANT!