08-16-2009, 01:34 PM
The pads have set so I gave them A good squaring up with a file and temporarily installed the signals to have a test fit.
Then it was on to the control panel. I just drilled some holes in some scrap wood, stained it and wired in some momentary double through switches. One for the east bound side and one for the west.
With the holes drilled to the underside of the layout I could then position the switch machines in there proper places and wire them in with a bank of resisters to soften the action of the switch machines.
Then it was on to the control panel. I just drilled some holes in some scrap wood, stained it and wired in some momentary double through switches. One for the east bound side and one for the west.
With the holes drilled to the underside of the layout I could then position the switch machines in there proper places and wire them in with a bank of resisters to soften the action of the switch machines.
My other car is a locomotive, ARHS restoration crew