10-05-2009, 08:18 PM
Look at the trip pin to make sure it's not pushed too far down so that it binds in the pivot holes. I haven't had any do this since I stopped painting them and using Goo to hold the springs in.
I would go with gently twisting it back and forth.
I would go with gently twisting it back and forth.
David
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.