02-09-2010, 09:54 PM
have not seen or used a walthers one, but did some time back have a turntable that had the same problem forget who the maker was but to solve the problem i used a idea from a old marklen table, i installes a home made coil with a 1/4 pin turned down to 1/8 at the end with a spring to hold ot out , i them painted the ring of the table with flat black then applied power to coil aligned track where i wanted it cut power to coil causing pin to make a mark on the paint, repowered coil moved bridge out of the way then drilled it with a drill just over 1/8 inch (think it was a 3.5mm drill).to move table i powered the coil moved table the were it needed to be and cut power to coil causing pin to ingage the hole holding it solid. kinda a pain to make but it did work. you might be able to fimd a junk marklin table and use coil off it.
jim
jim