03-23-2010, 11:59 AM
In my recent experience (like last month 
) I was about to forego the shelf brackets altogether because of the cost. However, I went back to the idea and eventually purchased some because of two reasons. One, I had some 18.5" brackets and 9" brackets left over from the last shelving project (layout and magazine support). Two, I found I could use half as many if I spaced them mostly on every other stud instead of every 16". At that point the cost was more managable.
You may be able to save $ on the vertical standards as well if you don't plan on having shelves above or below the layout. I used 24" standards because I won't be needing an upper shelf. I'd have had to find 36" or 30" standards in order to leave enough spacing between framing and the upper valance for sky & backdrop. Personally I don't like upper valances, as my eyes are drawn up into that space, defeating the purpose of trying to put the focus on the trains. It's a distraction, IMO.
These brackets are designed to handle alot of weight. If you get the standard lined up with the stud and use a long enough screw (I used #10, 2-1/2" screws after drilling a pilot hole), and you frame the layout well, you should have no problem with wider spacing. My layout framing will be constructed in order to line up with the brackets and put a brace in between brackets...a picture will explain better, I'm sure, when I get that far.
I haven't looked closely at your #s yet, but I'd say consider using 18.5" brackets instead of 24". I only used 2, 24" brackets where the track 'bridge' across the room will connect at either side, in order to proved additional support.
Galen
) I was about to forego the shelf brackets altogether because of the cost. However, I went back to the idea and eventually purchased some because of two reasons. One, I had some 18.5" brackets and 9" brackets left over from the last shelving project (layout and magazine support). Two, I found I could use half as many if I spaced them mostly on every other stud instead of every 16". At that point the cost was more managable.You may be able to save $ on the vertical standards as well if you don't plan on having shelves above or below the layout. I used 24" standards because I won't be needing an upper shelf. I'd have had to find 36" or 30" standards in order to leave enough spacing between framing and the upper valance for sky & backdrop. Personally I don't like upper valances, as my eyes are drawn up into that space, defeating the purpose of trying to put the focus on the trains. It's a distraction, IMO.
These brackets are designed to handle alot of weight. If you get the standard lined up with the stud and use a long enough screw (I used #10, 2-1/2" screws after drilling a pilot hole), and you frame the layout well, you should have no problem with wider spacing. My layout framing will be constructed in order to line up with the brackets and put a brace in between brackets...a picture will explain better, I'm sure, when I get that far.
I haven't looked closely at your #s yet, but I'd say consider using 18.5" brackets instead of 24". I only used 2, 24" brackets where the track 'bridge' across the room will connect at either side, in order to proved additional support.
Galen
I may not be a rivet counter, but I sure do like rivets!