04-12-2010, 08:42 PM
Rob:
The debugging technique is to remove one circuit at a time from the transformer and see if anything clears up.
Also check all joints in the wires going to the switches and then to the track blocks. Make sure no switch has the two control wires touching or the control and the return.
Turn one of your transformer plugs upside down where it goes into the wall (if the prongs allow it) -- you may have a cross connection in the wires or the track.
The debugging technique is to remove one circuit at a time from the transformer and see if anything clears up.
Also check all joints in the wires going to the switches and then to the track blocks. Make sure no switch has the two control wires touching or the control and the return.
Turn one of your transformer plugs upside down where it goes into the wall (if the prongs allow it) -- you may have a cross connection in the wires or the track.
David
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.