I cut a hole in the wall... now what?
#11
I just read my original post about the foam... it should say "take some fiberglass insulation OR some newspaper and stuff it in the hole..."

I think it would be a neat way to seal up the hole. Now, my first inclination was to cut some 2x4s to length, then screw some deck screws (at an angle so you can remove them later) in the wide face of the baord to use as a handle, then place it between the two pieces of sheetrock, and screw through the sheetrock into the 2x4. Remove the handle screws, caulk, and you are good to go!
Three Foot Rule In Effect At All Times
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)