08-09-2010, 01:57 PM
Sorry to hear that. Nice looking loco!
I assume that you have tried all the standard trouble shooting:
- wiring issues (although with PCBs on board, this can be impossible to figure out)
- DCC decoder issues
- binding siderods, etc
- track issues incl. wiring
- dirt/conductivity issues
Unfortunately, there are some things that just seem to defy diagnosis. I am a bit surprised they did not simply replace it for you. That was my experience with a P2K Heritage steamer. I sent it to them (pre-Walthers acquisition) and they simply shipped a new one.
Andrew
I assume that you have tried all the standard trouble shooting:
- wiring issues (although with PCBs on board, this can be impossible to figure out)
- DCC decoder issues
- binding siderods, etc
- track issues incl. wiring
- dirt/conductivity issues
Unfortunately, there are some things that just seem to defy diagnosis. I am a bit surprised they did not simply replace it for you. That was my experience with a P2K Heritage steamer. I sent it to them (pre-Walthers acquisition) and they simply shipped a new one.
Andrew