09-05-2010, 06:38 AM
Now I felt that I should get going on the bridge it's self.I started by drawing the towers out in full size on some foam board. Really paying attention to keeping all the joints at right angles. I checked and checked again to make sure I was happy with it before I started building anything. The foam board will act as a template, so it has to be correct.
I Cut some Central Vally #1902-5 bridge girders as per my drawing and glued them in place. The next step was to hold them down using pins stuck into the foam board.
I will have to make 4 of them . They consist of Type A girders on the top and bottom with Type B-B as the remainder of the girders.
I Cut some Central Vally #1902-5 bridge girders as per my drawing and glued them in place. The next step was to hold them down using pins stuck into the foam board.
My other car is a locomotive, ARHS restoration crew