11-13-2010, 11:49 AM
Hello!
@Steamtrain
![[Image: DSC00997.JPG]](http://www.us-modellbahnen.de/cp/albums/userpics/DSC00997.JPG)
This boiler backhead and cab floor was made of styrene sheet.
Only the curved piece has to be bended in form.
If you dive the styrene in hot water it will soften a little and so you can bend it. Fix it until it has cooled down, so it will hold its new form.
If not satisfied try it again until it has the right fit.
For not scalding your fingers take two pliers
Good luck!
Greetings Lutz
@Steamtrain
This boiler backhead and cab floor was made of styrene sheet.
Only the curved piece has to be bended in form.
If you dive the styrene in hot water it will soften a little and so you can bend it. Fix it until it has cooled down, so it will hold its new form.
If not satisfied try it again until it has the right fit.
For not scalding your fingers take two pliers
Good luck!
Greetings Lutz