12-03-2010, 07:09 AM
Angie, thanks for the reply, What I am trying to understand is when we are told to adjust a certain variable in a CV change bit number X. I know that they are telling me to change bit X but how is it done. I can't go below the basic CV number with the PA I get only CV X "enter" Data "enter"
Yesterday I was adjusting some sound properties on a locomotive and the instructions were clear. Here is an example of the steps:
CV 49 "enter" Data "0" "enter" CV 52 "Enter" Data (1-15) "enter" which adjusts the volume of a certain function. (The value entered into 49 opened the section of 52 to change the value I believe)
I also understand adding bit values as in CV 29 to make the decoder function with the long address, But on these other CV how do you know what values to add together to get where you want to go.
Charlie
Yesterday I was adjusting some sound properties on a locomotive and the instructions were clear. Here is an example of the steps:
CV 49 "enter" Data "0" "enter" CV 52 "Enter" Data (1-15) "enter" which adjusts the volume of a certain function. (The value entered into 49 opened the section of 52 to change the value I believe)
I also understand adding bit values as in CV 29 to make the decoder function with the long address, But on these other CV how do you know what values to add together to get where you want to go.
Charlie