12-06-2010, 03:19 PM
Started on the girder paint. Found some details I had not considered. First, the small yellow squares, two on each girder section at the bottom. Seems I completely overlooked those, so I took some leftover girder rivet plate from the ME bridge, used a hobby knife to scrape it to a very thin cross section, then cut the pieces and glued them on. First photo shows the pieces and where I scraped the paint off for the glue.
Then upon closer examination, it seems there are not actually plates in those locations, it is just different colored paint. Well, I am leaving my rivet plates on, will paint them yellow, close enough!
Then upon closer examination, it seems there are not actually plates in those locations, it is just different colored paint. Well, I am leaving my rivet plates on, will paint them yellow, close enough!
Three Foot Rule In Effect At All Times