12-20-2010, 10:39 PM
You can make a point filing jig out of a board with a groove cut in it -- just cut the groove at the right angle for the point. Make sure the groove tapers up about the middle of the board. You may have to compensate for the wide flat bit at the bottom of the rail.
And a sharper angle will let you file the frog V.
And a sharper angle will let you file the frog V.
David
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.