01-11-2011, 04:39 PM
jerry1313 Wrote:The switch was NOT isolated and I am using DCC and DC both by interconnecting the controllers. I have temporarily put the switch in the other direction (where the straight part is in-line with the loop) and it works fine. I also put a terminal railer in the sidings so I can isolate them and run the sidings with the DC Controller and the rest of the layout with DCC. Does that make sense as I dexcribe it?
OK, First, what "controllers" are you using? If it's the Bachmann EZ command, then OK, it's designed to do that. If you're using a different system, you may have a problem.
Also, if you're wiring the DC controller AND the DCC controller to the track, without a toggle switch, you're doing it wrong.
