02-19-2011, 09:18 PM
biL: I wish I had a heat gun, it would offer much more control. The candle did not allow me to make the indentions that I wanted. The depressions are there, but not as uniform as I had hoped for. On the candle, I have one that is 3" diameter and 3" tall. I just held the plastic over it until I could just see the deformation occuring. Then I put the plastic down on an upside down jar lid, and pressed gently downward, and cooled it with some water.
Randy: good thought on the stripes hiding the sandpaper joints, but some of the joints would have to be where there are no lines. For example, the long drive behind the bank. Stripes run lengthwise, but the joints would run across it.
Harry: thanks!
Here's a photo with gray paint on and a couple of dark washes.
Randy: good thought on the stripes hiding the sandpaper joints, but some of the joints would have to be where there are no lines. For example, the long drive behind the bank. Stripes run lengthwise, but the joints would run across it.
Harry: thanks!
Here's a photo with gray paint on and a couple of dark washes.