04-24-2011, 09:08 AM
I found a real tool to make a proper looking hill/cliff side from the durabond. just let it get to the point it is set fairly well, but not hard and drag this through it in the same direction until you are satisfied with the layering.
Then add the color of your choice. I have done the layer of brown. I use the Plaid brand from walmart and thin it about 50/50 or a little better with rubbing alcohol. Next step is to add some yellow and light gray to the wash and go over it. I have found it turns out best if you let it dry before adding different shades.
Charlie
Then add the color of your choice. I have done the layer of brown. I use the Plaid brand from walmart and thin it about 50/50 or a little better with rubbing alcohol. Next step is to add some yellow and light gray to the wash and go over it. I have found it turns out best if you let it dry before adding different shades.
Charlie