new project

[e-paw]

I tested a ballast mix on a section of track in Easton to see how it would look, so far so good. At first it was very glossy, but the sheen toned down after a few days as it dried. It's made from a mix of mason sand, tile grout, and a small amount of coal dust. At first I was concerned that it would amplify the sound of cars and locos rolling over it, but luckily there is little to no difference in the noise volume.

   

I did this in a spot that will be covered up, so if I didn't really like it, that section would not be noticed.