3 houses in Poughkeepsee,NY

[IndyCity]

Since the next steps to the house will repeat now, there are pictures of it again only if the street front is finished.
So now the parking lot, who is cut from a 1mm Styrene sheet.


Here an unmirrored excerpt from Gert Weinmann's picture of the entering.

Since the area in the original is not quite level, I have covered the whole area below with strips of 1mm. Previously, I've cut out the part of the entering.



The entrance area is also taped over again with a 0.5mm plate. It gave me a base for further work in this area. All edges are beveled more or less in the asphalt area with the blade.



Then I glued a strip 2x2.5mm as a curb.



The cracks between the curbs I scratched with the knife.

Directly in front of the entering there is a rainwater collector installed a little deeper. I've cut out that section of the entering and drinded the ground down there on a larger area to 0.5mm.



To let the edge in the step to the other asphalt surface not be quite so hard, I've glued there a 0.5mm stripbefore i glued in the whole thing.



Then everything was plastered to pay off for small errors. Also, I have grinded the whole area in various directions for the wash, and scratched "cracks" with the knife tip.



Finally, I built the encirclement of the rainwater collector from Styrenestrips and filled them with putty. The grid will be a etched part. Then only the asphalt strip out on the road was missing that climbs from 0.5 mm to 2.5 mm.



The coming days I will do the wash. Let's see if it looks like the parking lot of Gray S. in his thread.
He gave the Instruction to make it as I did. Thanks to him.

Btw. I hope my translations are not to far from how it has to be