09-01-2011, 05:41 AM
That looks good! The gray ground cover in the foreground of the lower photo is very level/flat. How do you do that?
I have severe problems to get it really level. I get the fine ballast/sand etc. level on the ground. I spray it with a fine mist of water/alcohol. When I put the glue/water mix with a pipette each drop makes a little crater. If I move the pipette while the glue is dropping it creates little channels.
I do later on soak it with more water and sprinkle some more ground cover on to cover the craters and channels but it is far from perfection.
I have severe problems to get it really level. I get the fine ballast/sand etc. level on the ground. I spray it with a fine mist of water/alcohol. When I put the glue/water mix with a pipette each drop makes a little crater. If I move the pipette while the glue is dropping it creates little channels.
I do later on soak it with more water and sprinkle some more ground cover on to cover the craters and channels but it is far from perfection.
Reinhard