10-13-2011, 06:57 PM
Here is the Brewery after a couple of hours work:
The next step was to print the buildings.
Then I used 3M general purpose spray adhesive to attach them to plywood and Masonite backing (I have lots of little scraps laying around.)
after the glue set up, I sprayed the paper with a heavy coat of flay finish Krylon clear, and when it was good and dry I cut them out with my 15 inch scroll saw
After cutting I sprayed another coat of Krylon, and used some craft paint to paint the edges.
Just to see what they would look like I stuck them against the backdrop and took this picture. (the sky is a photoshop because this section isn't done yet.)
Charlie
The next step was to print the buildings.
Then I used 3M general purpose spray adhesive to attach them to plywood and Masonite backing (I have lots of little scraps laying around.)
after the glue set up, I sprayed the paper with a heavy coat of flay finish Krylon clear, and when it was good and dry I cut them out with my 15 inch scroll saw
After cutting I sprayed another coat of Krylon, and used some craft paint to paint the edges.
Just to see what they would look like I stuck them against the backdrop and took this picture. (the sky is a photoshop because this section isn't done yet.)
Charlie