01-22-2012, 07:45 AM
Southern Tuxedo Wrote:Matt,
This is looking better and better every day. It is amazing how much you are accomplishing in a short amount of time. Ok, I just realized that you are in the “Resolution Challenge”, so now it makes sense.
How did you cut the ABS plastic pipe to get a clean, square end in order for you to cap it with styrene and what type of glue or solvent did you use to make the bond?
Mark
Mark,
I cut the ABS pipe with my table saw. The safest trick to get a perfect square cut is to clamp the pipe with 2 wood blocks to avoid the pipe to spin (safest). You use the gaurd and the sliding guide too.
Ralph Wrote:That's a great mock up. Feels like railroading already!
Ralph
It's about time to order tracks!
BTW, you remember when I let down Christie Brown and Canadian Breweries warehouses. We finally built them on the club layout last night... Recycling good ideas!!!
Matt
Proudly modelling Quebec Railway Light & Power Company since 1997.
Hedley-Junction Club Layout: http://www.hedley-junction.blogspot.com/
Erie 149th Street Harlem Station http://www.harlem-station.blogspot.com/
Hedley-Junction Club Layout: http://www.hedley-junction.blogspot.com/
Erie 149th Street Harlem Station http://www.harlem-station.blogspot.com/