02-22-2012, 08:23 AM
Okay, If it will run on DC wiring, it will run on DCC on the same wiring - so looking at it as a DC wired layout it needs to be done under the following rules
#1 Always feed from the narrow end of a turnout
#2 When the wide ends of two turnouts point towards each other alway break both rails between them
-so you need insulated joiners in BOTH rails whever there is a solid blacl ine across the tracks, and feeds at the triangles
then it should work
#1 Always feed from the narrow end of a turnout
#2 When the wide ends of two turnouts point towards each other alway break both rails between them
-so you need insulated joiners in BOTH rails whever there is a solid blacl ine across the tracks, and feeds at the triangles
then it should work