My girlfriend's work thread

[Sumpter250]

As you can see, the water has crept up against the tape along the edge. Any ideas how to remove this?
Svein

The viscosity of the WS "water" increases its surface tension, and causes it to "creep".
The only thing I can think of to remove the "ridge" caused, would be to tape a straight edge at the height of the water
surface , and use it as a guide to remove the "ridge" with a sharp ( single edge razor blade? ) cutting tool......or, just leave it as is, you will see the cut edge, though it may not be as obnoxious as the ridge.