08-11-2012, 08:16 PM
Take out the hard-drive from the blown computer and install it in the new one. Take note of where the cables are plugged in BEFORE taking it out. Install the drive into the new computer and connect the cables into one of the additional ports. The OpSys should recognize it and assign it as "D" drive when you start the computer back up. If it doesn't recognize it...it's (the disk drive) blown as well.
Of course, this should be done with the computer turned off AND unplugged.
Good luck..!!
Of course, this should be done with the computer turned off AND unplugged.
Good luck..!!
Gus (LC&P).