Building the Walthers N Blast Furnace ~~ Start to Finish

[Trucklover]

Here I have assembled the Furnace halfs, the Bust Pipe, the Mantle ring to the Bust Pipe, the Bell Hopper, and the Sheaves to the Sheave Rod.



Step 2
Here I have assembled the Bell Beams and the Trolley Support. I then put the Bell Beam in place on the Trolley Supports and also glued the Sheaves and Sheave Rod in place on the top of the Trolley Supports.



Step 3
Next I glued the Trolley Braces in (front and rear tops) and glued the Mantle Ring and Bust Pipe to the Furnace.



Step 4
I glued the Bell Platform to the Furnace.



Step 5
I put the pipes together but only glued in a couple spots (it says to leave the others unglued for now for later assemble. this was just a pre-assemble on how it goes together) and placed the Trolley Supports in postion, again, not glued in place yet.