Building and Kitbashing the Walthers Cornerstone Rolling Mil

[Trucklover]

Here is one of the 14 Roof Supports that will span the length of the building.



The Roof Supports have been painted a Rust color using "Rust" color Primer.



Step 2
Here is the Rolling Mill Skeleton. This is with both of them bashed together so this is the final length of the building. I glued the Supports to the base and then added the Crane Support Beams in.



A look down the supports of the Mill. You can see the imbeded tracks in the floor.



Step 3
These are the end walls. Walthers gives you the choice of having a completely enclosed structure or having the 3 open doors fot the tracks that run through the building. I chose to fo open doors as you will see in a few pics. This is one of 2 end walls that will be used in this kitbash.



Here are the side walls, there are 8 of them. Just like the end walls, Walthers gives you the choice of having the walls go all the way down to the bottom floor or having the bottom floor open so that you can see inside. I chose to have the bottom florr open so this wall is the shortened version.



Here is the roof Vent Housing that goes ontop of the roof to allow the tremendous heat that is created during the mill process to escape. Most mills also leave the bottom floor open to allow some of the heat to escape to. There are 2 of these vent housings that will be on the roof of the mill.