11-29-2012, 09:08 PM
I put a metal piece on the rails -- it should have a bit of mass, but I use track gauges as they keep the rails in place as the ties solidify again. Heat sink goes as close to the soldered area as possible; they only draw off the heat that is going to be wasted anyway.
David
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.
Moderato ma non troppo
Perth & Exeter Railway Company
Esquesing & Chinguacousy Radial Railway
In model railroading, there are between six and two hundred ways of performing a given task.
Most modellers can get two of them to work.