12-07-2012, 02:07 PM
I agree with Pete ....and at this point with everything ballasted , you'll have to solder the feeder wires to the outside of the rail ( the inside might interfere with the wheels of your locos/rolling stock ). I think it should be done to every section of track but at this point that probably is going to very very difficult for you . You would need two heavier gauge buss wires , one for each side of the track rails for the appropriate feeded to connect to . If it is difficult to solder feeder wires to the buss you could use "suitcase connectors " that can be found at Home Hardware . I use 14 ga wire for the buss and 18 ga wire for the feeders ( I like solid , not stranded ) . Hooking up SOME feeders will help your situation . Hopefully you don't have reverse loops to complicate things .
T
T
To err is human, to blame it on somebody else shows management potential.