01-02-2013, 07:20 PM
The number of locomotives shouldn't matter unless the amp draw is exceeding the limit. You should be able to press select loco and choose another loco. Mine only holds two numbers in recall, but I usually have 4-5 sitting on the track at one time. I've never had an issue with selecting a locomotive.
To reset the power cab, turn the power on, unplug the cab, and then hold select loco as you plug the cab back into the bus. This will open the programming mode. Keep pressing enter until you get to the prompt to reset the cab. Follow the instructions, and voila! The cab will be reset. Hope this helps!
Chuck
To reset the power cab, turn the power on, unplug the cab, and then hold select loco as you plug the cab back into the bus. This will open the programming mode. Keep pressing enter until you get to the prompt to reset the cab. Follow the instructions, and voila! The cab will be reset. Hope this helps!
Chuck
Detroit Connecting
We are your
inner-city connection.
We are your
inner-city connection.