tetters' Duff Challenge part duex

[tetters]

I was able to fix this, but driving it all the way through would not have worked only because the hole drilled was into the side of the "A" end of the model. There was no other side, just more styrene... I was able to carefully file it down and then drilled another hole right on top. Oddly enough, the drill template included with these models seems to want to place the holes on the "A" end a little crooked, the new hole is actually more level.

Funny you mention breaking these, I've broken another bit since this one and was beginning to think I was just being too ham fisted with them. But they are very small bits aren't they... :?