03-03-2013, 07:56 PM
Well - after working on it last night - I had some time today to get off y duff 
The speaker enclosure is finished and as soon as it dries and I paint it all black, it's going in!!!!!! This is yet another "Redesign During Construction"! 
Inside looking "upward"
The top looking down. The white parts are the sides. The knob which will face the rear of the engine is the on/off volume control.
The front - Note the grille extension and also the clean "new" wood
Now the wood is "weathered"
And finally - sitting the roof on again to make sure everything looks right And I think I'll remove the top board so the engineer can see without having to look out the sides of the engine 
The speaker enclosure is finished and as soon as it dries and I paint it all black, it's going in!!!!!!
This is yet another "Redesign During Construction"! Inside looking "upward"
The top looking down. The white parts are the sides. The knob which will face the rear of the engine is the on/off volume control.
The front - Note the grille extension and also the clean "new" wood
Now the wood is "weathered"
And finally - sitting the roof on again to make sure everything looks right
And I think I'll remove the top board so the engineer can see without having to look out the sides of the engine
~~ Mikey KB3VBR (Admin)
~~ NARA Member # 75
~~ Baldwin Eddystone Unofficial Website
~~ I wonder what that would look like in 1:20.3???
~~ NARA Member # 75
~~ Baldwin Eddystone Unofficial Website
~~ I wonder what that would look like in 1:20.3???