06-28-2013, 01:12 PM
First steps of my "white Swan" reefers are done. All sheetings are ground off - and my wife was very lucky with all that white dust.
After them I glued four thin layers under bottom and so car bodies raised for a 1/4 inch - the right dimension in order to get the 10' 2" inside height of these cars.
![[Image: whiteswan_044k.jpg]](http://us-modelsof1900.de/wp-content/gallery/whiteswan-reefer/whiteswan_044k.jpg)
Look picture a second time and you can see the light dark boundaries to additional layers below of bodies.
Here yet a link back to the very similar but old picture with the low bodies for comparison.
After them I glued four thin layers under bottom and so car bodies raised for a 1/4 inch - the right dimension in order to get the 10' 2" inside height of these cars.
![[Image: whiteswan_044k.jpg]](http://us-modelsof1900.de/wp-content/gallery/whiteswan-reefer/whiteswan_044k.jpg)
Look picture a second time and you can see the light dark boundaries to additional layers below of bodies.
Here yet a link back to the very similar but old picture with the low bodies for comparison.
Cheers, Bernd
Please visit also my website www.us-modelsof1900.de.
You can read some more about my model projects and interests in my chronicle of facebook.
Please visit also my website www.us-modelsof1900.de.
You can read some more about my model projects and interests in my chronicle of facebook.