Atlas Nscale SD60 Short Circuit Problem

[Herc Driver]

I've about...oh...I dunno...about thirty engines that I still need to install a dcc board in. Most are the "DCC Ready" type where I'll need to trim a little here and there to make them fit. I've installed about 20 decoders so far I think, but these two SD60 units were the most problematic. With the new engines I currently have on order, I just bit the bullet and ordered them with the dcc already factory installed. I don't mind doing the installation...but it sure would be a bit easier on my time to have a few less to switch over.