04-01-2019, 12:30 PM
Well, trim painting never was my forte' but a second coat will be needed as well as some scraping where it looks like I used a four inch brush. I should have waited for warmer conditions but I can repair my mistakes. I just had to keep doing stuff.
I have the sign glued to the polystyrene waiting for the glue to dry then I can cut it out and bolt it to the building.
For the roofing I can see in the original picture that it was corrugated metal so I used an old EIDE computer cable and burnished some aluminum foil over it to get the material
You have to pull the eraser in the same direction but it is a cheap way to make corrugated metal.
I want to try doing some with foil tape but I didn't have any on hand.
I have to wait for glue to dry to trim the edges and then a little roof coating and jut a tiny bit of rust.
Charlie
I have the sign glued to the polystyrene waiting for the glue to dry then I can cut it out and bolt it to the building.
For the roofing I can see in the original picture that it was corrugated metal so I used an old EIDE computer cable and burnished some aluminum foil over it to get the material
You have to pull the eraser in the same direction but it is a cheap way to make corrugated metal.
I have to wait for glue to dry to trim the edges and then a little roof coating and jut a tiny bit of rust.
Charlie