06-01-2010, 07:17 PM
The above picture shows the Battery, the circuit board and the 2 Crimp Connectors I installed after cutting off the LED (It's under the crimp connectors.)
After cutting the wires and attaching the connectors, I then found the High Bright LED and attached Crimps to it too.
This photo shows the tiny "Original LED (Green Arrow) and the newer larger High Brightness Red LED (Red Arrow) before the connectors were attached.
After cutting the wires and attaching the connectors, I then found the High Bright LED and attached Crimps to it too.
This photo shows the tiny "Original LED (Green Arrow) and the newer larger High Brightness Red LED (Red Arrow) before the connectors were attached.
~~ Mikey KB3VBR (Admin)
~~ NARA Member # 75
~~ Baldwin Eddystone Unofficial Website
~~ I wonder what that would look like in 1:20.3???
~~ NARA Member # 75
~~ Baldwin Eddystone Unofficial Website
~~ I wonder what that would look like in 1:20.3???