07-26-2010, 11:58 PM
Got a bit done tonight. The bottom and sides are cut and glued together around the DIN rail. Next to go on is the top and the ballast retainer sections. All of this stuff is easy and straightforward - just various rectangles glued together. The DIN rail section inside makes it very stiff and straight, but still lightweight because it is aluminum. The pipe supports will be the tedious part of this one.
Darn... just realized that I didn't scribe the section lines in the sides. Would have been easier to scribe them before they were glued on. No big deal though.
Darn... just realized that I didn't scribe the section lines in the sides. Would have been easier to scribe them before they were glued on. No big deal though.
Three Foot Rule In Effect At All Times