09-09-2010, 11:24 PM
biL, I like it too! 
Okay, progress photos - got 8 of the 10 bents in place - cut rectangular slots in the foam, filled them almost full with modeling clay, set the bents in place leaving them just a little taller than needed, then took the bridge (attached to a level which was really just used as a straight edge) and set it down, pressing the bents into the clay, leaving the bents at the proper height. Then removed the bridge and filled the slots with EasySand 20, letting it go around the poles.
Still have to add the two bents that are in the water. Then it will be some sand and dirt over the foam, then the horizontal boards between the bents.
Okay, progress photos - got 8 of the 10 bents in place - cut rectangular slots in the foam, filled them almost full with modeling clay, set the bents in place leaving them just a little taller than needed, then took the bridge (attached to a level which was really just used as a straight edge) and set it down, pressing the bents into the clay, leaving the bents at the proper height. Then removed the bridge and filled the slots with EasySand 20, letting it go around the poles.
Still have to add the two bents that are in the water. Then it will be some sand and dirt over the foam, then the horizontal boards between the bents.
Three Foot Rule In Effect At All Times