11-14-2010, 03:55 PM
Moving on to the Brakeman's side "remember it a Camel back not an end cab". The only visible detail is are two sets of pipes " one being lagged" and a valve handle. I built these the same way as the other parts, the only addition is the lagging. This was made with a strip of masking tape wrapped around it.
It was then glued in place with some CA.
I put the cab back on for another shot.
It was then glued in place with some CA.
I put the cab back on for another shot.
My other car is a locomotive, ARHS restoration crew